Flow properties of a dusty-gas point source in a supersonic free stream

By using Lagrangian method, the flow properties of a dusty-gas point source in a supersonic free stream were studied and the particle parameters in the near-symmetry-axis region were obtained . It is demonstrated that fairly inertial particles travel along oscillating and intersecting trajectories between the bow and termination shock waves . In this region, formation of " mufti- layer structure" in panicle distribution with alternating low- and high density layers is revealed. Moreover, sharp accumulation of particles occurs near the envelopes of particle trajectories .     

Heating characteristics of blunt swept fin-induced shock wave turbulent boundary layer interaction

An experimental study was conducted on shock wave turbulent boundary layer interactions caused by a blunt swept fin-plate configuration at Mach numbers of 5.0, 7.8, 9.9 for a Reynolds number range of (1.0∼4.7)×10⁷/m. Detailed heat transfer and pressure distributions were measured at fin deflection angles of up to 30° for a sweepback angle of 67.6°. Surface oil flow patterns and liquid crystal thermograms as well as schlieren pictures of fin shock shape were taken. The study shows that the flow was separated at deflection of 10° and secondary separation were detected at deflection of ϑ≥20°. The heat transfer and pressure distributions on flat plate showed an extensive plateau region followed by a distinct dip and local peak close to the fin foot. Measurements of the plateau pressure and heat transfer were in good agreement with existing prediction methods, but pressure and heating peak measurements atM≥6 were significantly lower than predicted by the simple prediction techniques at lower Mach numbers. The project supported by China Academy of Launch Vehicle Technology     

The structure and evolution of a two-dimensional H2/O2/Ar cellular detonation

This paper reports on two-dimensional numerical simulation of cellular detonation wave in a / / mixture with low initial pressure using a detailed chemical reaction model and high order WENO scheme. Before the final equilibrium structure is produced, a fairly regular but still non-equilibrium mode is observed during the early stage of structure formation process. The numerically tracked detonation cells show that the cell size always adapts to the channel height such that the cell ratio is fairly independent of the grid sizes and initial and boundary conditions. During the structural evolution in a detonation cell, even as the simulated detonation wave characteristics suggest the presence of an ordinary detonation, the evolving instantaneous detonation state indicates a mainly underdriven state. As a considerable region of the gas mixture in a cell is observed to be ignited by the incident wave and transverse wave, it is further suggested that these two said waves play an essential role in the detonation propagation.Received: 16 September 2003, Accepted: 14 June 2004, Published online: 20 August 2004[/PUBLISHED]PACS: 47.40.-x, 82.40.Fp, 82.33.Vx, 83.85.PtX.Y. Hu: Correspondence to Current address: Institut für Strömungsmechanik, Technische Universität Dresden, 01062 Dresden, Deutschland     

Singular behaviour and asymptotic stress field of a crack terminating at a bimaterial interface

A crack terminating at an interface of two dissimilar elastic materials is investigated. It is found that the asymptotic stress field near the crack tip is in general composed of two parts with each part being characterized by one singularity. The detailed relation of the two singularities with the bimaterial properties is given for some special cases of the crack.     

Regiospecific Synthesis of N-Sulfanilyl Heterocyclic Ketene Aminals

Heterocyclic ketene aminals 1 or 2 reacted with N-acetylsulfanilyl chloride 3 in the presence of sodium hydride to afford N-sulfanilyl heterocyclic ketene aminals 4 or 5 regiospecifically.     

Synthesis and mesomorphic properties of novel fishbone-like liquid crystalline polysilsesquioxanes VI. Fishbone-like,ester-based liquid crystalline polysilsesquioxanes

Two novel kinds of fishbone-like, ester-based, liquid crystalline, random copolysilsesquioxanes, LC₁-CH₃-P and LC₂-CH₃-P, have been synthesized for the first time by stepwise coupling polymerization (SCP) from trichlorosilane monomers (RSiCl₃) containing mesogenic ester groups, using three main steps including preaminolysis, hydrolysis and polycondensation. Two new monomers 4-(11-trichlorosilylundecloyloxy)phenyl 4-methoxybenzoate (M₁) and 4-(3-trichlorosilylpropoxy)phenyl 4-methoxybenzoate (M₂) have been synthesized by hydrosilylation reaction of trichlorosilane and the mesogens 4-n-undecenoyloxyphenyl 4-methoxybenzoate and 4-allyloxyphenyl 4-methoxy-benzoate, respectively, in the presence of dicyclopentadienylplatinum(II) chloride (Cp₂Ptcl₂) catalyst. The structures and mesomorphic properties of LC₁-CH₃-P and LC₂-CH₃-P were investigated by FTIR, ¹H NMR, ¹³C NMR, ²⁹Si NMR, gel permeation chromatography, polarizing optical microscopy, differential scanning calorimetry and X-ray diffraction. It is proposed from the characterization data that these two polymers not only have an ordered ladder-like, double main chain, but also show thermotropic smectic behaviour with high clearing points and wide mesophase ranges (ΔT), which may hold promise for potential applications as highly stable gas chromatographic stationary phases.     

New series of AB2‐type hyperbranched polytriazoles derived from the same polymeric intermediate: Different endcapping spacers with adjustable bulk and convenient syntheses via click chemistry under copper(I) catalysis

In this article, according to the concept of “suitable isolation group,” six new AB₂‐type polytriazoles containing azo‐chromophore moieties, derived from the same hyperbranched polymer intermediate, were successfully prepared through click reaction under copper(I) catalysis by modifying the synthetic route, in which different isolation groups in different size were introduced to the periphery of the hyperbranched polymers as end‐capping moieties. With the different end‐capping groups, these hyperbranched polymers, P1 – P6 , exhibited different solubility and processability; also, their nonlinear optical properties were modified accordingly, realizing the adjustment of the properties of hyperbranched polymers through the structural design. © 2011 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2011     

Formation and tribological properties of two‐component ultrathin ionic liquid films on Si

Several single‐component and two‐component imidazolium ionic liquids (ILs) ultrathin films were formed on Si substrates by a dip‐coating and heat treatment process. The formation and surface properties of the films were analyzed by means of ellipsometric thickness measurement, X‐ray photoelectron spectra and atomic force microscope. The adhesive and nanotribological behaviors of the films were evaluated by a homemade colloidal probe. A ball‐on‐plate tribometer was used to test the microtribological performances of these films. As a result, the two‐component ILs ultrathin film containing 80% solid‐like ILs phase shows more homogenous surface morphologies and optimal micro/nano‐tribological properties as compared to single‐component ILs films, which is ascribed to a synergic effect between the steady solid‐like ILs phase as the backbone and the proper amount of flowable liquid‐like ILs phase. By studying the influence of various solid/liquid ILs ratios on tribological properties of the two‐component ILs films, we might find the way to design ILs films with excellent comprehensive tribological properties. Copyright © 2010 John Wiley & Sons, Ltd.     

Global convergence property of modified Levenberg-Marquardt methods for nonsmooth equations

In this paper, we discuss the globalization of some kind of modified Levenberg-Marquardt methods for nonsmooth equations and their applications to nonlinear complementarity problems. In these modified Levenberg-Marquardt methods, only an approximate solution of a linear system at each iteration is required. Under some mild assumptions, the global convergence is shown. Finally, numerical results show that the present methods are promising.